1997 Toyota Camry LE Sedan 4-Door Cylinder Head Installation
download 1. Install cylinder head. A. Place cylinder head on cylinder block. (a) Place a new cylinder head gasket on the cylinder block. CAUTION: Be careful of the installation direction. (b) Place the...
View Article1995 Mercury Villager Water Pump Removal Installation
download 1. Drain the cooling system. Refer to Section 03-03 for the procedure. 2. Disconnect the battery ground cable (14301) . 3. Remove the generator drive belt, water pump and power steering pump...
View Article1994 Mercury Villager Water Pump REMOVAL AND INSTALLATION
download Water Pump Removal 1. Drain the cooling system. Refer to Section 03-03. 2. Disconnect the battery ground cable (14301) . 3. Remove the generator drive belt, water pump and power steering pump...
View Article2006 Mazda5 BODY VIBRATION AT CRUISE SPEED
download DESCRIPTION Some vehicles may experience a body vibration when driving approximately 55mph. This symptom is due to the characteristics of the No. 3 & No. 4 engine mounts. Modified No. 3...
View ArticleOil Filter Cap Assembly Precautions
download To prevent damage to the oil ?lter cap assembly, this procedure must be closely followed during oil ?lter replacement to avoid immediate and future oil ?lter serviceability concerns. The...
View Article2004 Ford F-150 Oil Pan, Oil Pump, Oil Pump Screen and Pickup Tube IN-VEHICLE...
download 1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-00. 2. If oil pump removal is necessary, remove the timing drive components. For...
View Article1995 Ford Windstar Engine Front Cover REMOVAL AND INSTALLATION
download Engine Front Cover If the engine front cover (6019) is being removed to check timing chain deflection, refer to Timing Chain Deflection Procedure as outlined in Section 03-00. SPECIAL SERVICE...
View Article2004 Mazda 6 i WATER PUMP DRIVE BELT Removal Installation
download WATER PUMP DRIVE BELT 1. Verify that the water pump drive belt auto tensioner indicator mark does not exceeds the limit. ? If it exceeds the limit, replace the water pump drive belt. (See...
View Article2002 Jeep Wrangler CMP and CKP Removal and Installation
download The Camshaft Position Sensor (CMP) on the 4.0L 6cylinder engine is bolted to the top of the oil pump drive shaft assembly. The sensor and drive shaft assembly is located on the right side of...
View Article2003 Buick Century Engine Oil and Oil Filter Replacement Removal Procedure
download 1. 2. 3. 4. 5. Raise and support the vehicle. Refer to Vehicle Lifting. Position the oil drain pan under the engine oil drain plug. Remove the engine oil drain plug. Clean and inspect the...
View Article